FULL

...
Aplications

  • For harder Class III and Class IV type burrs.
  • Deburring coarse burrs.
  • Good for flat surfaces.
Sectors

  • Industry: Engineering, Aeronautics, Automotive, Sintered Metals.
 ccm brush range -  Flexible Abrasives
Outside
Ø
Ø
Arbor Hole
Trim Length SILICIUM CARBIDE - Grit DIAMOND - Grit
mm "
mm " mm " 80 120 320 80 120 320
115 4.1/2” 14 9/16” 25 1” CCM11580CSFL CCM11512CSFL CCM11532CSFL CCM11580DFL CCM11512DFL CCM11532DFL
150 6” 20 3/4” 30 1.3/16” CCM15080CSFL CCM15012CSFL CCM15032CSFL CCM15080DFL CCM15012DFL CCM15032DFL
Outside
Ø
Ø
Arbor Hole
Trim Length CERAMIC - Grit ALUMINUM OX. - Grit
mm "
mm " mm " 80 120 320 80 120 320
115 4.1/2” 14 9/16” 25 1” CCM11580CRFL CCM11512CRFL CCM11532CRFL CCM11580OAFL CCM11512OAFL CCM11532OAFL
150 6” 20 3/4” 30 1.3/16” CCM15080CRFL CCM15012CRFL CCM15032CRFL CCM15080OAFL CCM15012OAFL CCM15032OAFL

JAZ "CCM" brushes are mainly composed of nylon filaments impregnated with: Silicon carbide, aluminum oxide, diamond, ceramic coating, etc.

The “CCM” line is designed to be mounted as a tool for use in machining centers, robots, flexible cells, etc.

The "CCM" brushes provide a variety of solutions such as deburring, blending and finishing, rounding of edges, contouring of edges and refinement of surfaces.

Our abrasive filament brushes can be run dry (without a coolant), however applying a “coolant” to the abrasive filaments will improve the finish and performance of the tool.

Industries such as Automotive, Aeronautics, Sintered Metals, etc., where surface finishing is important, can find a solution to many surface finishing problems with JAZ “CCM” brushes.

Tool Holder for CCM Brushes

For the correct mounting of CCM brushes in CNC machines, we recommend to use the Tool Holder.

The Tool Holder is designed to provide the best performance of CCM brushes.

Manufactured in one solid piece to improve the balancing and the life of the tool.

The design allows the coolant to flow through the Tool Holder, reducing the heating and also avoiding rust corrosion.

ccm brush range - Flexible Abrasives

Class of Burr

ccm brush range - Flexible Abrasives

CLASS I

Micro Burrs can only be seen with magnification.

CLASS II

Feather Burrs can be seen without magnification. They can be removed with your fingernail.

CLASS III

Well attached small burrs are small in nature, but require a lot of force to be removed.

CLASS IV

Well attached large burrs are large in nature and have a larger attachment point than a CLASS 111 burr.

CLASS V

Extruded burrs are very large burrs that extrude from the base material. These burrs need to be preconditioned before brushing.