TURBO

...
Characteristics
  • Turbo brushes are the most practical and impressive brushes in the entire range.
  • Medium deburring for Class II and Class III type burrs.
Aplications

  • For rounding and roughing edges.
  • Recommended for flat surfaces, where all burrs are on a flat surface.
Sectors

  • Industry: Engineering, Automotive, Aeronautical, Sintered.
Cepillos CCM - Abrasivos Flexibles
Outside
Ø
Ø
Arbor Hole
Trim Length SILICIUM CARBIDE - Grit DIAMOND - Grit
mm "
mm " mm " 80 120 320 80 120 320
115 4.1/2” 14 9/16” 25 1” CCM11580CSTR CCM11512CSTR CCM11532CSTR CCM11580DTR CCM11512DTR CCM11532DTR
150 6” 20 3/4” 30 1.3/16” CCM15080CSTR CCM15012CSTR CCM15032CSTR CCM15080DTR CCM15012DTR CCM15032DTR
Outside
Ø
Ø
Arbor Hole
Trim Length CERAMIC - Grit ALUMINUM OX. - Grit
mm "
mm " mm " 80 120 320 80 120 320
115 4.1/2” 14 9/16” 25 1” CCM11580CRTR CCM11512CRTR CCM11532CRTR CCM11580OATR CCM11512OATR CCM11532OATR
150 6” 20 3/4” 30 1.3/16” CCM15080CRTR CCM15012CRTR CCM15032CRTR CCM15080OATR CCM15012OATR CCM15032OATR

JAZ "CCM" brushes are mainly composed of nylon filaments impregnated with: Silicon carbide, aluminum oxide, diamond, ceramic coating, etc.

The “CCM” line is designed to be mounted as a tool for use in machining centers, robots, flexible cells, etc.

The "CCM" brushes provide a variety of solutions such as deburring, blending and finishing, rounding of edges, contouring of edges and refinement of surfaces.

Our abrasive filament brushes can be run dry (without a coolant), however applying a “coolant” to the abrasive filaments will improve the finish and performance of the tool.

Industries such as Automotive, Aeronautics, Sintered Metals, etc., where surface finishing is important, can find a solution to many surface finishing problems with JAZ “CCM” brushes.

Tool Holder for CCM Brushes

For the correct mounting of CCM brushes in CNC machines, we recommend to use the Tool Holder.

The Tool Holder is designed to provide the best performance of CCM brushes.

Manufactured in one solid piece to improve the balancing and the life of the tool.

The design allows the coolant to flow through the Tool Holder, reducing the heating and also avoiding rust corrosion.

ccm brush range - Flexible Abrasives

Class of Burr

ccm brush range - Flexible Abrasives

CLASS I

Micro Burrs can only be seen with magnification.

CLASS II

Feather Burrs can be seen without magnification. They can be removed with your fingernail.

CLASS III

Well attached small burrs are small in nature, but require a lot of force to be removed.

CLASS IV

Well attached large burrs are large in nature and have a larger attachment point than a CLASS 111 burr.

CLASS V

Extruded burrs are very large burrs that extrude from the base material. These burrs need to be preconditioned before brushing.