BUNDLE
- Designed for edge deburring and surface finishing.
- The position of the filaments allows to enter in small bores or difficult areas access.
- Suitable for Class I and II burrs.
- Recommended for deburring surfaces where all burrs are on the same level.
- Industry: Engineering, Aeronautics, Automotive, Sintered Metals and many more.

Outside Ø |
Ø Arbor Hole |
Trim Length | SILICIUM CARBIDE - Grit | DIAMOND - Grit | |||||||
mm | " |
mm | " | mm | " | 80 | 120 | 320 | 80 | 120 | 320 |
115 | 4.1/2” | 14 | 9/16” | 25 | 1” | CCM11580CSBU | CCM11512CSBU | CCM11532CSBU | CCM11580DBU | CCM11512DBU | CCM11532DBU |
150 | 6” | 20 | 3/4” | 30 | 1.3/16” | CCM15080CSBU | CCM15012CSBU | CCM15032CSBU | CCM15080DBU | CCM15012DBU | CCM15032DBU |
Outside Ø |
Ø Arbor Hole |
Trim Length | CERAMIC - Grit | ALUMINUM OX. - Grit | |||||||
mm | " |
mm | " | mm | " | 80 | 120 | 320 | 80 | 120 | 320 |
115 | 4.1/2” | 14 | 9/16” | 25 | 1” | CCM11580CRBU | CCM11512CRBU | CCM11532CRBU | CCM11580OABU | CCM11512OABU | CCM11532OABU |
150 | 6” | 20 | 3/4” | 30 | 1.3/16” | CCM15080CRBU | CCM15012CRBU | CCM15032CRBU | CCM15080OABU | CCM15012OABU | CCM15032OABU |
JAZ "CCM" brushes are mainly composed of nylon filaments impregnated with: Silicon carbide, aluminum oxide, diamond, ceramic coating, etc.
The “CCM” line is designed to be mounted as a tool for use in machining centers, robots, flexible cells, etc.
The "CCM" brushes provide a variety of solutions such as deburring, blending and finishing, rounding of edges, contouring of edges and refinement of surfaces.
Our abrasive filament brushes can be run dry (without a coolant), however applying a “coolant” to the abrasive filaments will improve the finish and performance of the tool.
Industries such as Automotive, Aeronautics, Sintered Metals, etc., where surface finishing is important, can find a solution to many surface finishing problems with JAZ “CCM” brushes.
Tool Holder for CCM Brushes
For the correct mounting of CCM brushes in CNC machines, we recommend to use the Tool Holder.
The Tool Holder is designed to provide the best performance of CCM brushes.
Manufactured in one solid piece to improve the balancing and the life of the tool.
The design allows the coolant to flow through the Tool Holder, reducing the heating and also avoiding rust corrosion.

Class of Burr

CLASS I
Micro Burrs can only be seen with magnification.
CLASS II
Feather Burrs can be seen without magnification. They can be removed with your fingernail.
CLASS III
Well attached small burrs are small in nature, but require a lot of force to be removed.
CLASS IV
Well attached large burrs are large in nature and have a larger attachment point than a CLASS 111 burr.
CLASS V
Extruded burrs are very large burrs that extrude from the base material. These burrs need to be preconditioned before brushing.